PB-265ESL 21-25G-00 INTRODUCTION CONTENTS page We are constantly working on technical im- 1 SERVICE INFORMATION ......2 provement of our products. For this reason, 1-1 Specifi cation ..........2 1-2 Technical data ..........3 technical data, equipment and design are 1-3 Torque limits..........
SERVICE INFORMATION PB-265ESL 1 SERVICE INFORMATION 1-1 Specifi cations Dimensions Length* mm(in) 305 (12.0) Width* mm(in) 410 (16.1) Height mm(in) 435 (17.1) Dry weight** kg(lb) 6.1 (13.4) Engine Type KIORITZ, air-cooled, two-stroke, single cylinder Rotation Anticlockwise as viewed from the output end Displacement 25.4 (1.55)
Location Remarks Thread locking sealant Engine mount Loctite # 242, ThreeBond 1324 or equivalent Fun hub Starter pawl Loctite # 222, ThreeBond 1342 or equivalent Muffl er cover Grease Rewind spring Lithium based grease or ECHO LUBE Starter centre shaft...
PB-265ESL SERVICE INFORMATION 1-5 Service limits 5K204 5K263 5K264 5K265 5K266 5K016 5K017 5K267 5K219 5K171 Description mm (in) Cylinder bore When plating is worn and aluminum can be seen Piston outer diameter Min. 33.91 (1.335) Piston pin bore Max.
SERVICE INFORMATION PB-265ESL 1-6 Special tools Key Part Number Description Used for: 897801-33330 Tachometer PET-1000 Measuring engine speed 363018-00310 Washer Installing crankcase oil seal of starter side 895610-79920 L-hex wrench (4 mm) Removing and installing hex. socket bolts (M5) 897603-23030...
PB-265ESL SERVICE INFORMATION 2 CARBURETTOR ADJUSTMENT PROCEDUTER 2-1 General adjusting rules A. Before starting the unit for adjustment, check the following items. 1. The correct spark plug must be clean and properly gapped. 2. The air fi lter element must be clean and properly installed.
SERVICE INFORMATION PB-265ESL 2-3 Adjusting carburettor 1. Start engine and warm it up alternating engine speed between WOT and idle every 10 seconds for 1 minute. 2. Adjust idle mixture needle (A) with 2.5 mm blade screwdriver (E) to reach maximum engine speed just before drop off.