Specifications; Fcc Information - Radio Shack 15-309 User Manual

Slim universal remote control
Table of Contents

Advertisement

Specifications

Power requirement ............................................................................................................. 1 CR2032 battery
Battery life .....................................................................................................................approx. 22,000 hours
Specifications are typical; individual units might vary. Specifications are subject to change and
improvement without notice. Actual product may vary from the product images in this document.

FCC Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult your local RadioShack store or an experienced electronics technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using your remote. Changes or modifica-
tions not expressly approved by RadioShack may cause interference and void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents