Table of Contents
Advertisement
Introduction
This chapter provides unpacking instructions, hardware preparation, and installation
instructions for the MVME167. The MVME712X transition module hardware
preparation is provided in separate manuals. Refer to Related Documentation in
Chapter 1.
Unpacking Instructions
N
If the shipping carton is damaged upon receipt, request carrier's
ote
agent be present during unpacking and inspection of equipment.
Unpack equipment from shipping carton. Refer to packing list and verify that all items
are present. Save packing material for storing and reshipping of equipment.
C
Avoid touching areas of integrated circuitry; static discharge
aution
can damage circuits.
Hardware Preparation
To select the desired configuration and ensure proper operation of the MVME167,
certain option modifications may be necessary before installation. The MVME167
provides software control for most of these options. Some options can not be done in
software, so are done by jumpers on headers. Most other modifications are done by
setting bits in control registers after the MVME167 has been installed in a system. (The
MVME167 registers are described in Chapter 4, and/or in the
MVME166/MVME167/MVME187 Single Board Computers Programmer's Reference
Guide as listed in Related Documentation in Chapter 1.)
The location of the switches, jumper headers, connectors, and LED indicators on the
MVME167 is illustrated in Figure 2-1. The MVME167 has been factory tested and is
shipped with the factory jumper settings described in the following sections. The
MVME167 operates with its required and factory-installed Debug Monitor,
MVME167Bug (167Bug), with these factory jumper settings.
Settings can be made for:
General purpose readable register (J1)
MVME167/D32-1
HARDWARE PREPARATION
AND INSTALLATION
2
Advertisement
Table of Contents
