Yamaha MM700H Owner's Manual page 76

For MM700
1. Remove the handlebar cover 1.
2. Loosen the handlebar bolts.
3. Move the handlebar up or down (± 7°) to adjust the
handlebar height to the desired position.
CAUTION :
@
Make sure that the projection on the handlebar is not
installed into the area a shown.
@
4. Tighten the handlebar bolts and install the handlebar
cover.
Handlebar bolt tightening torque:
23 Nm (2.3 m·kg, 17 ft·lb)
CAUTION :
@
Make sure that the small gap b side of the handlebar
holders faces forward c.
@
8-25