Using Set Menu; Sound Menu - Yamaha RX-V359 Owner's Manual

Using SET MENU

Use the remote control to access and adjust each
parameter.
TEST
PROG
LEVEL
2,3
y
• You can change the "SET MENU" parameters while this unit is
reproducing sound.
• You can use NEXT (A/B/C/D/E) and SET MENU +/–
(PRESET/TUNING l / h) on the front panel to change these
settings, if "TUNER" is not selected as the input source. Press
NEXT to select the category or field you wish to change, and
SET MENU +/– to change the parameters.
1
Press SET MENU repeatedly to display the
desired menu and then press + to enter the
menu.
y
Once you press SET MENU, you can also select the menu
by pressing u / d.
2
Press u / d repeatedly to select the item and
then press +/– to change the parameter.
Depending on the menu item, press u / d to select a
sub item, and then press +/– to change the parameter.
3
To exit, press u / d repeatedly until the
menu disappears.
STRAIGHT
VOLUME
PROG
MUTE
SET MENU
1
VOLUME

SOUND MENU

Use this menu to manually adjust any speaker settings.
Notes
• If you select "SETUP" (see page 20) and then select "SET"
after adjusting the "SOUND MENU" parameters, the "SETUP"
parameters override the "SOUND MENU" parameters. Do not
enter "SETUP" unless you wish to change the "SOUND
MENU" parameters. If you accidentally enter "SETUP", select
"CANCEL" to exit from "SETUP".
• Some menu item settings have no effect when the unit is
reproducing a source with a digital signal sampling frequency
greater than 48 kHz.
Speaker settings
Use this feature to manually adjust any speaker setting.
y
If you are not satisfied with the bass sounds from your speakers,
you can change these settings according to your preference.
Center speaker 1A CENTER
Choices: LRG (large), SML (small), NON (none)
• Select "LRG" if you have a large center speaker. The
entire range of the center channel signals is directed to
the center speaker.
• Select "SML" if you have a small center speaker. The
low-frequency signals of the center channel are
directed to the speakers selected with "1D BASS".
• Select "NON" if you do not have a center speaker. The
entire range of the center channel signals is directed to
the front left and right speakers.
Front speakers 1B FRONT
Choices: LRG (large), SML (small)
• Select "SML" if you have small front speakers. The
low-frequency signals of the front channel are directed
to the speakers selected with "1D BASS".
• Select "LRG" if you have large front speakers. The
entire range of the front left and right channel signals is
directed to the front left and right speakers.
SET MENU
1 SPEAKER SET
45