Handlebar Switches - Yamaha KODIAK 400 Owner's Manual

EBU00053

Handlebar switches

1. Light switch " / /OFF"
2. Engine stop switch "
3. Start switch " "
EBU12510
Light switch " /
Set the switch to "
beams, the taillight and the meter lighting.
Set the switch to "
beams, the taillight and the meter lighting.
Set the switch to "OFF" to turn off all the lights.
/ "
/OFF"
" to turn on the low
" to turn on the high
CAUTION:
_
Do not use the headlights with the engine
turned off for more than thirty minutes.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
_
EBU12050
Engine stop switch "
Make sure that the engine stop switch is set to
" " before starting the engine. The engine
stop switch controls ignition and can be used
at all times to stop the engine, especially in an
emergency. The engine will not start or run
when the engine stop switch is set to "
4-7
/ "
".