Dry Ironing - Binatone SI-5000 I-Flash Instruction Manual

! Prior to first use iron a clean old piece of cotton cloth to make sure
the sole plate and the water tank are absolutely clean (see
Steam ironing Steam ironing
subsection «Steam ironing Steam ironing Steam ironing»).
INSTRUCTIONS FOR USE
1) Place the iron into a vertical position.
2 ) Insert the power plug into the mains supply
3 ) The fabric setting «ÐÅÆÈÌÛ» and «
4) Turn the Select Knob (7)
tion «Select Knob Functions Select Knob Functions Select Knob Functions Select Knob Functions»).
Select Knob Functions
5) Press the « » indicator on the display (see Figure B
fabric type according to recommended temperature settings (see
the manufacturer's label). Allow the iron to be heated up until the
Fabric Setting indicator light stops blinking and the buzzer beeps.
Note: During operation of the appliance the light indicator
(10) will light up and turn off periodically; this is
normal and not a malfunction.
Select Knob Functions

Dry ironing

Dry ironing can be used at any temperature setting.
To do this the Select Knob (7)
position « ».
Steam ironing
If you intend to use the steam function, allow the iron to heat to
the required temperature level then turn the Select Knob (7)
desired steam output.
Attention: The «Drip Stop» system automatically
terminates the steam generation process if the selected
temperature is too low. When the system is activated,
you may hear a click.
Turbo steam
To ease ironing of dense cotton, linen and upholstery articles
turn the Select Knob (7)
Knob (7) (7) (7) (7) for an extra blast of steam: engagement of the button (7)
during the ironing process generates an extra burst of steam from
the sole plate to help remove stubborn creases.
Burst of steam in a vertical position
This function helps to fresh the appearance of curtains, jackets,
coats, etc. To use this function, take the following steps:
! Follow instructions in paragraph 1-5 of the section «Instruc-
tions for use tions for use
tions for use tions for use tions for use». While selecting the temperature setting, turn
the Select Knob (7)
outlet.
light in blue on the display (8), at the same
time, the colour changeable indicators (10)
at two sides of reservoir light in blue.
(7) (7)
(7) (7) to the Dry iron position «
(7) (7) must be turn to the Dry iron (7)
(7)
(7) (7)
(7) (7) to the position «
(7) (7) to the position « (7)
(7)
6 6 6 6 6
» (see subsec-
see Figure B) to set the see Figure B see Figure B
see Figure B
(7) to the (7) (7)
(7)
», then press the Select
Instruc- Instruc- Instruc- Instruc-
».
»