Getting Ready - Bissell PowerFresh 1440-J Series User Manual

O
perations

Getting ready

The mop pad may have already come
attached to the mop head, if not follow
steps 1A and 1B below.
1. Add freshening Disc and Attach mop Pad
A. Insert Spring Breeze freshening Disc
into pocket inside mop pad. Use the
whole disc for a refreshing scent or
cut in half for a lighter scent.
B. Set mop head in mop pad, making
sure quick-grip release tab is located
on the back.
2. For tank with filter
fill the water tank
A. Remove tank by lifting straight up
and away from unit.
B. Press down on the filter Release
Button and slide filter forward to
access Water Tank.
C. fill tank with water. for best results,
water should be at room temperature.
D. Slide filter back onto the Water Tank
until it clicks into place.
E.
Replace water tank by gently
sliding tank into place and press
down firmly.
3. Twist the Quick Release™ cord wrap
clockwise to unwrap the power cord
completely and plug into a 220-240 Volt
outlet as described on the Important
Safety Instructions, page 3.
4. SmartSet™ Steam Select Indicator light
will glow when Powerfresh Steam mop
is ready to use. Press the Steam Level
button to choose the level of steam you
desire. Depress the Steam-on-Demand
trigger located on the handle to begin
steam cleaning.
w w w . b i s s e l l . c o m
1A
2A 2B
2D
Tip:
Use of distilled water is
recommended to prolong the life
of your Powerfresh Steam mop.
NOTE: Upon first use of the
PowerFresh™ Steam Mop
or first use after refilling the
water tank, the pump may
make a "knocking" sound.
This is normal and should
only last a few seconds.
1B
7