Table of Contents
Advertisement
Source IP address: Enter an IP address. After you set the IP address, the
incoming packets (protocol selected packets) are allowed.
Source port: UPD/TCP source port or a range of ports.
Destination IP address: destination IP (default: null).
Destination port: UPD/TCP destination port or a range of ports.
DSCP Mark: Marking DSCP that outgoing packets.
WAN interfaces: You can select WAN interfaces and PVC.
The following is an example of configuring the incoming IP filtering:
Request
I need to permit a PC whose IP address is 10.10.10.10. All Incoming
TCP/UDP packet traffic from that PC (10.10.10.10) is allowed.
Block all IP traffic from other PCS.
Configuration
Step 1
By default, all incoming IP traffic from Internet is blocked. Hence, all
incoming IP packets from other PCS except PC (10.10.10.10) are
blocked.
Step 2
The detailed configuration steps are as follows:
DSL-X11 User Manual
50
Advertisement
Table of Contents
