Working With The Mixer - Bifinett KH 701 Operating Instructions Manual

Risk of injury from rotating parts!
To avoid personal injury and damage to the applian-
ce, NEVER insert or place your hands or foreign ob-
jects into the loading shaft. Only insert ingredients by
use of the stodger.
Only change accessories when the drive motor j
is at standstill! After being switched off, the drive motor
j continues to run for a short time. The appliance
may only be used when the drive openings not being
utilised are covered with drive protection lids. In ca-
ses of malfunction switch the appliance off and re-
move the plug from the wall socket, this will avoid
an unintentional switching-on of the appliance.
On task completion
• Switch the appliance off with the rotary switch g .
• Turn the food processor u anti-clockwise and
remove it.
• Disassemble the food processor u and clean all
parts (see chapter „Cleaning and care").

Working with the mixer

Risk of scalds!
Allow hot fluids to cool to a hand-warm temperature
(ca. 30–40°C) before they are poured into the
mixer r .
Proceed as follows to prepare the appliance for opera-
tion with the mixer r :
• Press the unlocking button f and bring the
swivel arm h into operating position 3 (see
chapter „Operating positions").
• Remove the drive protection lid for the mixer
(Fig. 7).
• Fit the mixer r (Marking on the base onto the
marking on the base machine) and turn it anti-
clockwise as far as it will go (Fig. 8).
• Fill with ingredients.
Maximum amounts: 1 litre;
foaming liquids, maximum 0,5 litre;
optimal processing amount for solids: 50–100 g
Note: Take note of the table in the chapter
„Recommended filling quantities".
• Place on the lid with funnel and press it down
firmly (Fig. 9).
• Set the rotary switch g to the desired level.
Risk of injury from sharp knife/
rotating drive!
NEVER reach into the mixer r when it is in use!
Remove/place the mixer r only when the drive
motor j is at stillstand! Only use the mixer r with
the lid firmly in position.
In cases of malfunction switch the appliance off and
remove the plug from the wall socket, this will avoid
an unintentional switching-on of the appliance.
Refilling with ingredients
• Turn the appliance off with the rotary switch g .
• Press the button on the handle of the mixer r ,
remove the lid and fill with ingredients
or
• remove the funnel and slowly refill with solids
through the refill opening (Fig. 10)
or
• refill with fluid ingredients by means of the
trichter (Fig. 11).
On task completion
• Switch the appliance off with the rotary switch g .
• Turn the mixer r clockwise and remove it.
Note: The mixer r is best cleaned immediately
after use (see chapter „Cleaning and care").
- 26 -