Final Gear Oil - Yamaha TEO'S XN125 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
TOTAL
1
ZAUM0041
1. "TRIP" button
To reset the oil change indicator light
1. Push the "TRIP" button while
turning the key to "ON".
2. Release the reset button, and the
oil change indicator light will go off.
NOTE:
If the engine oil is changed before the
oil change indicator light comes on (i.e.
before the periodic oil change interval
has been reached), the indicator light
must be reset after the oil change for
the next periodic oil change to be
indicated at the correct time. To reset
the oil change indicator light before the
periodic oil change interval has been
reached, follow the above procedure.
ZAUM0042
1. Oil filler bolt

Final gear oil

The final gear case must be checked
for oil leakage before each ride. If any
leakage is found, have a Yamaha dea-
ler check and repair the scooter. In ad-
dition, the final gear oil must be
changed as follows at the intervals
specified in the periodic maintenance
and lubrication chart.
1. Place the scooter
centerstand.
NOTE:
Make sure that the scooter is positioned
straight up when checking the oil level.
A slight tilt to the side can result in a
false reading.
6-12
1
ZAUM0043
1. Oil drain bolt
EAU02961
2. Place an oil pan under the final gear
case to collect the used oil.
3. Remove the oil filler bolt and drain
bolt to drain the oil from the final
gear case.
4. Install the final gear oil drain bolt,
and then tighten it to the specified
torque.
Tightening torque:
on the
Final gear oil drain bolt:
22 Nm (2.2 m•kg)
1
6