How to apply Back-Side Permanent
Adhesive Transfer
•
Steps 1, 2 and 3... same as above.
•
Remove the protective clear mask
layer and discard.
•
This process removes excess adhesive
from everywhere except the back of
the item run through the machine.
Replacement Cartridges
Product
No.
Description
AT400-300
Adhesive Application – High Tack
AT402-300
Adhesive Application – Low Tack
AT406-170
Adhesive Application –
DL403-300
Two-Sided Lamination
SL403-300
One-Sided Lamination
LAT405-300
Combination Lamination/Adhesive
Application – High Tack
LAT406-300
Combination Lamination/Adhesive
Application – Low Tack
LAT409-170
Combination Lamination/Adhesive
Application – Repositionable
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
•
Remove the document from the white
release liner when you're ready to
mount it.
Applications
Paste-ups, comps, storyboards
& presentations on foam core
Paste-ups, comps, storyboards
& presentations on foam core
Paste-ups, comps, storyboards
Repositionable
& presentations on foam core
Posters, inkjet & thermal
prints & banners
Indoor applications where protection
of the rear side is not needed
Paste-ups, comps, storyboards &
presentations on foam core,
provides protection to top surface
Paste-ups, comps, storyboards &
presentations on foam core,
provides protection to top surface
Paste-ups, comps, storyboards &
presentations on foam core,
provides protection to top surface
Feet
Per Roll
300
300
170
300
300
300
300
170