Fitting The Vapour Protection; Fixing To The Adjacent Units; Adjusting The Door Balance - Westinghouse SI 910 SA Care And Use Manual

Fitting the vapour protection

Fit the adhesive protection foil onto the front part of
the worktop, along the entire width.

Fixing to the adjacent units

To prevent the dishwasher tilting, it must be
secured to either the worktop or adjacent kitchen
cabinet/wall using the brackets supplied. Insert the
two fixing brackets into the slots provided in the top
front part of the dishwasher as shown in the figure.
Secure the brackets to adjacent units with the 3.5 x 16
screws using the upper or the side holes.
The appliance must be secured to the
underside of the worktop using the brackets
provided.
Failure to do this could cause damage or
injury.

Adjusting the door balance

When the dishwasher door is correctly balanced it
will remain in position when left ajar. The door
balance may need to be adjusted when the decor
panel is fitted. Turn the screws until the correct
balance is reached:
- heavy panel - turn clockwise
- light panel - turn anticlockwise
After the adjustment of the door balance, cover the
screw holes with the two plugs supplied with the
machine.
II21
II54
II47
25
II68
PFI49GB