The Furniture Door - Westinghouse SI 910 SA Care And Use Manual

The furniture door

The door on this appliance is designed for the
overlay of a panel having the following dimensions:
Width 596 mm
Height 604 mm max
Thickness 20 mm max
Weight 2 - 7.5 kg max
The panel height should be no more than
indicated, otherwise complete opening of the
door will no longer be possible as the panel
hits against the dishwasher plinth.
The height of the panel depends on the height of
adjacent kitchen units (see "Kitchen plinth
adjustment").
Furtermore, it is possible to fine up the control
panel to correspond with the height of the drawers
of the adjacent pieces of furniture, thus perfectly
co-ordinating with the style of the rest of the unit
furniture in your kitchen.
Add one or more of the fillets provided until you
reach the desired height.
Secure the fillets as shown in the picture, by
means of two screws 4 x 40 provided therewith.
Prepare the panel as follows:
- Measure the distance (B) between the part
below the control panel (or fillets) and the
reference notch (X) on the door.
- Measure the same distance (B) on the wooden
panel starting from the upper edge.
At this distance position the supporting cross-bar
provided, in correspondence with the reference
(Z). Keep the same distance between the centre
of the support's fastening holes and the lateral
edges of the wooden panel.
- On the panel sign the seats for the four fastening
screws. Drill the panel with a Ø 2 x 12 bit and fix
the supporting cross-bar onto the wooden panel
with the 3.5 x 16 screws provided.
- Mount the decor panel by inserting the two pivots
of the cross-bar into the slotted holes of the door.
Lift the decor panel until the perfect alignment
with the facia panel is obtained.
Once the correct position has been found, open
the door and fasten the decor panel on the lower
section by means of the two 4 x 40 screws
provided, using the holes through the inner door.
A
II04
1
II22
II10
24
A
X
B
Z
B
2
PFI12/1GB