VTech Vonage IP 8100-2 Manual page 13

Setup
STEP 2
Disconnect all cables between your Cable or DSL modem and your computer.
STEP 3
Connect one end of the yellow ethernet cable to the yellow port, labeled "PC/
LAN," located on the back of the IP 8100-2/8100-3 base unit and connect the
other end of the yellow cable to the ethernet port of your computer.
STEP 4
Connect one end of the blue ethernet cable to the blue port, labeled "WAN," lo-
cated on the back of the IP 8100-2/8100-3 base unit and connect the other end
of the blue cable to the ethernet port on your cable or DSL modem.
STEP 5
Reconnect power cord to the modem then turn the modem on. Please wait until
all lights on the modem stop blinking.
Helpful Hint: This should take a few minutes, but may take as long as 10 min-
utes.
STEP 6
Plug the power cord into the power port located on the bottom or your IP 8100-
2/8100-3 and the other end into the electrical outlet. This turns the IP 8100-
2/8100-3 broadband telephone on.
Helpful Hint: DO NOT interrupt this registration process by unplugging the power
or by using the handsets until the READY indicator light on the front of IP 8100-
2/8100-3 base has gone from flashing yellow to a steady green.
Helpful Hint: Use only the power cord provided in this package; using an older
power cord can damage the broadband telephone.
STEP 7
Turn your computer on, and check your computer to see if your Internet is work-
ing, try to visit any website. If your Internet is working, please proceed to STEP
9. If not, please proceed to STEP 8.
STEP 8:
Cable Users
If you receive Internet access through a Cable modem, you may need to reg-
ister the IP 8100-2/8100-3 with your ISP. Please contact them to update your
information; you will likely need your WAN MAC address, which is located on
the bottom of the IP 8100-2/8100-3. Once your ISP has updated your account,
proceed to step 9.
-- OR --
10