Table of Contents
Advertisement
Multiplex
Connection Settings
Always ON
Connect on
Demand
IP Address
Get IP Address
IP Address
IP Subnet Mask
Gateway
NAT
Default Route
Dynamic Route
Direction
Multicast
Select Obtain an IP Address Automatically if you have a
dynamic IP address; otherwise select Static IP Address and
type your ISP assigned IP address in the IP Address field below.
Select the method of multiplexing used by your ISP from the
drop-down list. Choices are VC or LLC.
Select Always ON Connection when you want your connection
up all the time. The ADSL Router will try to bring up the
connection automatically if it is disconnected.
Connect on demand is dependent on the traffic. If there is no
traffic (or Idle) for a pre-specified period of time), the connenct
will tear down automatically. And once there is traffic send or
receive, the connection will be automatically on. Please insert
the Idle Time in minute.
The IP address can be either dynamically (via DHCP) or given
IP address provide by your ISP. For Static IP, you need to
specify the IP address, Subnet Mask and Gateway IP address.
You must specify a Router IP address.
Enter a subnet mask in dotted decimal notation.
Refer to the Subnetting appendix in the to calculate a subnet
mask If you are implementing subnetting.
You must specify a gateway IP address.
Select this option to Activate/Deactivated the NAT (Network
Address Translation) function for this VC. The NAT function can
be activated or deactivated per PVC basis.
if enable this function, the current PVC will be the default
gateway to internet from this device.
RIP (Routing Information protocol) Select this option to specify
the RIP version, including RIP-1, RIP-2M and RIP-2B. RIP-2M
and RIP-2B are both sent in RIP-2 format; the difference is that
RIP-2M using Multicast and RIP-2 using Broadcast format.
RIP Direction Select this option to specify the RIP direction.
None is for disabling the RIP function. Both means the ADSL
Router will periodically send routing information and accetp
routing information then incorporate into routing table. IN only
means the ADLS router will only accept but will not send RIP
packet. OUT olny means the ADLS router will only send but will
not accept RIP packet.
IGMP (Internet Group Multicast Protocol) is a session-layer
protocol used to establish membership in a multicast group. The
ADSL ATU-R supports both IGMP version 1 (IGMP-v1) and
A02-RA111 / A02-RA141
WebShare 111/141
Pag. 40
Advertisement
Table of Contents
