Channel Setting - Toshiba RDXV49DTKF Owner's Manual

E3TK0FD_EN.book Page 21 Monday, March 9, 2009 10:00 AM

Channel Setting

You can retune this unit or edit the channel setting with
following methods.
Auto Tuning (DVB & ANALOG)
DVB ANALOG
Programme the tuner to scan both analogue and DVB
channels you can receive in your area.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K L], then press [ENTER OK].
"General Setting" menu will appear.
2
Select "Channel" using [K L], then press
[ENTER OK].
3
Select "Auto Tuning (DVB & ANALOG)" using
[K L], then press [ENTER OK].
The unit will start storing channels available in your area.
General Setting
Playback
Display Country
Video Auto Tuning (DVB & ANALOG)
Recording DVB Channel Setup
Clock ANALOG Channel Setup
Channel
DivX
HDMI
DVB Setting
Reset All
Wait for several minutes to finish channel storing.
4
Press [SETUP] to exit.
You can select only the channels memorised in this unit
by using [PROG.
To cancel auto tuning
Press [SETUP] during scanning.
Note
• The number of TV channels you can get is different depends
on your local area.
• If the auto tuning is cancelled during scanning, some
channels not yet tuned may not be received.
Auto Tuning (ANALOG)
ANALOG
Programme the tuner to scan only the analogue channels you
can receive in your area.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K L], then press [ENTER OK].
2
Select "Channel" using [K L], then press
[ENTER OK].
3
Select "ANALOG Channel Setup" using [K L],
then press [ENTER OK].
].
4
Select "Auto Tuning" using [K L], then press
[ENTER OK].
The unit will start storing channels available in your area.
Wait for several minutes to finish channel storing.
5
Press [SETUP] to exit.
You can select only the channels memorised in this unit
by using [PROG. ].
To cancel auto tuning
Press [SETUP] during scanning.
Note
• The number of TV channels you can get is different depends
on your local area.
• If the auto tuning is cancelled during scanning, some
channels not yet tuned may not be received.
• When "Country" setting is set to "France", sorting of TV
channels from 1 to 6 will be performed automatically as
follows.
1: TF1 2: F2
4: CANAL+ 5: F5/ARTE
Manual Tuning (ANALOG)
ANALOG
You can preset an analogue channel manually and
individually.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K L], then press [ENTER OK].
2
Select "Channel" using [K L], then press
[ENTER OK].
3
Select "ANALOG Channel Setup" using [K L],
then press [ENTER OK].
4
Select "Manual Tuning" using [K L], then
press [ENTER OK].
5
Select "Position" using [K L], then press [B].
Position
System
Channel
Decoder
Skip
6
Select the position number you want to use
using [the Number buttons] or [K L], then
press [{].
• You can select position number 1-99.
• With [the Number buttons], you only need to enter the
last 2-digit numbers.
7
Select "System" using [K L], then press [B].
8
Select "L" or "BG" using [K L], then press
[{].
• If your system is SECAM-L, select "L".
• If your system is PAL-B/G, select "BG".
3: F3
6: M6
1
L
1
OFF
ON
21
EN