Select The Spin Speed Or Rinse Hold Option; Select The Delay Button; Select The Desired Option; Start The Programme - Zanussi Electrolux ZWF 14109 Instruction Booklet

7.Select the spin speed or Rinse
Hold Option
Press the "Spin" button repeatedly, in order to select
the desired spin speed or the Rinse Hold
The relevant LED will light up.
If you select the Rinse Hold
will stop at the end of the programme with the water
still in the tub.
ZWF 14109

8.Select the desired option

Press the relevent button to select the required
options. Depending on the selected programm, only
certain options are available and shown during the
selection phase.
Note: Not all the options are compatible with each
other. For the option that are not compatible, the
icons will disappear.
option.
option, the machine
16

9.Select the Delay Button

Before you start the programme if you wish the
starting to be delayed, press the DELAY button. The
figures corresponding to the selected delay will be
displayed for about 3 seconds, after which the
duration of the selected programme will appear on
the display.
During this period it is possible to load other laundry:
• Press "Start/Pause" button;
• load the laundry;
• close the door and press "Start/Pause" button
again.

10.Start the Programme

Press the "Start/Pause" button. The relevant LED will
stop flashing. and only the LED relevant to the phase
that is in progress will remain lit.
If you have chosen a delayed start, the washing
machine will begin the countdown.
The display will show the duration of the programme
or the selected delay.
11.How to change a programme
during its cycle
You can alter the programme before it starts.When
the programme has started, you can only reset it by
turning the programme selector dial to «Off» position
and then you can select the new programme. Start it
by pressing the "Start/Pause" button.
12.How to interrupt a programme
during its cycle
Press the "Start/Pause" button to interrupt a
programme which is running, the corresponding LED
starts to flash. Press the same button again to restart
the programme .