Local Station Tab - Siemens Gigaset USB Adapter DECT Operating Instructions Manual

Local station tab

Here you can make all the settings for data transmission, including the settings for the
partner station.
Identification
Name
Adapter type:
Hardware version: /
Firmware version:
Reset
Registered base stations
You can enter up to six base stations in the window. This allows you to connect the
Gigaset USB Adapter flexibly to the one and then the other base station.
Register
Unregister
Connect
The stations' names provide a fast overview. It's best to call
the local station "PC", the partner stations by connected
device, e. g. "Gigaset SX303/353isdn".
You can change a station name by editing or entering the
name in the name field, using letters, digits, space and
special characters. The name must not exceed 20 characters.
Your USB Adapter is operated as extension at the base
station.
The version numbers of the hardware and firmware are
displayed.
Use this function to restore the Gigaset USB Adapter
connected to the PC to its factory settings. You will see a
confirmation prompt which you have to acknowledge. All
the parameters and registrations are returned to their
default values. The partner station is not affected. If you
want to completely delete the connection, you will have to
run the Unregister function at the base station. Only then
are all the connection parameters deleted.
Create a new connection.
ì ì ì ì
Select a free registration location or registered base
station.
ì ì ì ì
Put the base station to be connected into registration
mode (see the base station operating instructions).
ì ì ì ì
Click Register.
ì ì ì ì
Enter the base station PIN
(1–8 digits, factory setting 0000).
Create a new connection.
ì ì ì ì
Select a registered connection.
ì ì ì ì
Click Unregister.
The registered base station is removed from the list.
Connect a registered connection.
ì ì ì ì
Select a registered connection.
ì ì ì ì
Click Connect.
Configuration
13