Installation; Shipping Bolts; Removing Shipping Bolts - Kenmore 501-40002 Owner's Manual And Installation Instructions

I nstallation
Install or store unit where it will not be exposed to temperatures below freezing or exposed to outside
weather conditions.
Properly ground washer to conform with all governing codes and ordinances.
To reduce the risk of electric shock, do not install the washer in humid spaces.
The base opening must not be obstructed by carpeting when the washer is installed on a carpeted floor.
In areas where there are areas which may be subject to infestation by cockroaches or other vermin, pay
particular attention to keeping the appliance and its surroundings in clean condition at all times.
Damage caused by cockroaches or other vermin will not be covered by the appliance warranty.

Shipping bolts

The appliance is fitted with shipping bolts to prevent internal damage during transport.

Removing shipping bolts

1. To prevent internal damage during transport,
4 locking bolts are installed. Before operating
the washer, remove the bolts.
• If they are not removed, it may cause severe
vibration, noise, and malfunction.
2. Unscrew the 4 bolts with the wrench
supplied.
6
3. Take out the 4 bolts by twisting the braces
slightly. Keep the 4 bolts and the wrench for
future use.
• Whenever the appliance is transported, the
shipping bolts must be replaced.
cap
4. Close the holes with the caps supplied.