Software Settings; Logic Audio Settings; Cubase Vst Settings; Sonar Settings (Windows) - Roland RPC-1 Owner's Manual

Software settings

This section explains the audio device settings that should be
made in order to use the RPC-1 with some representative
sequencer programs.

Logic Audio settings

Audio device settings
When using the ASIO driver
1. From the "Audio" menu, select "Audio Hardware &
Drivers." On the Windows version, click "Audio
Hardware & Drivers2" tab.
2. Check "ASIO," and from the pull-down menu choose
"Roland RPC-1 ASIO" (Win) or "ASIO2 RPC-1" (Mac).
When using the EASI driver (Windows)
1. From the "Audio" menu, select "Audio Hardware &
Drivers."
2. Check "PC AV," and select "Roland RPC-1 EASI."
When using the MME driver (Windows)
1. From the "Audio" menu, select "Audio Hardware &
Drivers."
2. Check "PC AV," and select "EASI MME."
3. Click the "Control Panel" button, and start up "MME to
EASI adapter."
4. Check the following devices.
• WavOut Roland RPC-1
• R-BUS In Roland RPC-1
• Monitor Mixer Roland RPC-1
18

Cubase VST settings

Audio device settings
1. In the "Options" menu, select "Audio Setup" and then
select "System."
2. Select "Roland RPC-1 ASIO"(Win) or "ASIO RPC-1"
(Mac).

Sonar settings (Windows)

Audio device settings (Windows 98/ME)
1. From the "Options" menu, select "Audio."
2. In the "Settings" tab, click "Devices."
3. In the "Input Device" area select following device.
• PCM In Roland RPC-1
• Mon.Mixer Roland RPC-1
4. In the "Output Device" area select "WavOut Roland
RPC-1."
5. Set the "playback timing master" to "WavOut 1/2
Roland RPC-1," and the "recording timing master" to
"PCM In 1/2 Roland RPC-1."
6. Click the "OK" button.
Audio device settings (Windows 2000/XP)
1. From the "Options" menu, select "Audio."
2. In the "Settings" tab, click "Devices."
3. In the "Input Device" area select "Roland RPC-1
Multichannel 1/2"–"Roland RPC-1 Multichannel
9/10."
4. In the "Output Device" area select "Roland RPC-1
Multichannel 1/2"–"Roland RPC-1 Multichannel
7/8."
5. Set the "playback timing master" to "Roland RPC-1
Multichannel 1/2," and the "recording timing master"
to "Roland RPC-1 Multichannel 1/2."
6. Click the "OK" button.