Table of Contents
Advertisement
Connections with the XV-5080
Example settings
RPC-1 settings (in the Control Panel)
• Master Clock: Int. Clock
• Int.Clock Sample Rate: either 44.1 or 48 kHz
XV-5080 settings
• Master Clock: R-BUS
For details on output destination settings of the XV-5080,
refer to "Chapter 3. Setting the output jacks" in the
XV-5080 manual.
The R-BUS of the XV-5080 is for output only. It cannot be
used for input to the XV-5080.
It is not possible to make MIDI connections using the R-BUS
of the XV-5080. To make MIDI connections, use the MIDI
connectors of the XV-5080.
Connections with the ADA-7000
Updating the system program
The version 1.02 or later system program is required in
order to connect and use the ADA-7000 with the RPC-1.
Updating the system program
The directory "UPDATE > ADA-7000" in the included
"DRIVER/UPDATE CD-ROM" contains the data for the
update. Perform the update procedure as directed by the
"readme.doc" file.
Example settings
RPC-1 settings (in the Control Panel)
• Master Clock: Int. Clock
• Int. Clock Sample Rate: either 32, 44.1, 48, or 96 kHz
ADA-7000 settings
• Master Clock: R-BUS
The analog inputs and outputs of the ADA-7000 can be used
as inputs and outputs of the RPC-1.
If you are using a sampling frequency of 96 kHz, using a five
meter R-BUS cable (RBC-5) may cause noise to occur. If you
are using a frequency of 96 kHz, use shorter cable.
Connections with other R-BUS devices
Connections with the AE-7000
Updating the system program
The version 1.01 or later system program is required in
order to connect and use the AE-7000 with the RPC-1.
Updating the system program
The directory "UPDATE > AE-7000" in the included
"DRIVER/UPDATE CD-ROM" contains the data for the
update. Perform the update procedure as directed in the
"readme.doc" file.
Example settings
RPC-1 settings (in the Control Panel)
• Master Clock: Int. Clock
• Int. Clock Sample Rate: either 32, 44.1, or 48 kHz
AE-7000 settings
• Master Clock: R-BUS
15
Advertisement
Table of Contents
