Safety Information - SENDO S230 User Manual

14

Safety information

You should observe and follow these guidelines for
the safe and efficient use of your phone. Failure to
comply with these guidelines and requirements
may void your warranty and may invalidate any
approvals given to your phone.
Radio Frequency Signals
Your phone transmits and receives radio frequency
(RF) signals whenever it is switched on. The design
of your phone complies with all relevant standards
and recommendations for human exposure to RF
energy. Your phones transmission power is
controlled by the cellular network at the lowest
possible level to maintain a good signal. You may
also choose to reduce your exposure to RF signals
by controlling the duration of your calls or by using
an accessory such as a handsfree device. Your
phone has been designed to comply with
applicable standards when used correctly in
accordance with the user instructions. A sample of
this phone model has been tested and found to
comply with the following directives, standards or
recommendations:
1999/5/EC • 89/336/EEC • 73/23/EEC as amended
by 93/68/EEC • 1999/519/EC • AS/NZS 2772.1
(Int):1998 • IEEE Std C95.1, 1999 Edition
Antenna Care and Efficient Operation
Do not use your phone if the antenna is damaged.
Replace the antenna only with one approved by the
manufacturer. Unapproved antennas or
modifications may damage your phone, degrade
its performance and violate local regulations. Do
not touch the antenna unnecessarily while a call is
in progress. Contact with the antenna affects call
quality and may cause your phone to transmit at a
higher power level than otherwise needed. Hold
your phone as you would any other phone. The
antenna should point up and over your shoulder.
Batteries
All batteries can cause property damage, injury or
burns if a conductive material such as jewellery or
keys comes into contact with the exposed
terminals. The material may complete an electrical
circuit and become quite hot. Exercise care in
handling your phone battery. For example, avoid
carrying your phone battery loose in a pocket or
purse. This product is designed for use with
manufacturer-approved batteries only. Use of
unapproved batteries may be dangerous and may
cause damage to the battery or the phone and may
void your warranty.
Accessories
Only use accessories approved by the
manufacturer. Using unapproved accessories with
your phone may result in degraded performance,
fire, electric shock or injury, and may void the
warranty. Please check with your dealer for the
availability of approved accessories. Your phone is
intended for use only with chargers approved by
the manufacturer.
Any other use will invalidate any approval given to
your phone and may be dangerous.
The mains (AC) charger is compatible only with
power sources indicated on its label. Do not
connect the charger to a power source of a different
voltage or frequency. Do not use the charger
outdoors or in areas where it may become wet.
Unplug the charger from the wall socket using the
body of the charger, not the cord. Locate the cord
so that it will not be tripped over, stepped on or
damaged. Do not use the charger if it is damaged.
Unplug the charger from the wall socket before
cleaning it. Use a slightly damp cloth for cleaning,
and allow the charger to dry fully before plugging it
in.
35
14