Sharp TM100 Operation Manual page 96

You cannot make a dotted semi quaver (dotted
semi quaver rest) or a dotted semi breve
(dotted semi breve rest).
Three continuous notes are required for a
triplet.
Specifying a tie
To specify a tie, press N
An underscore (_) is displayed next to the note, and the
note is tied with the next.
To enter the next note, press
the right, then repeat the operation to input the melody.
If the cursor is positioned next to a note, you can repeat
the note immediately left of the cursor by pressing
b
.
Sample steps to input melody
To get used to inputting melodies, input the simple
melody shown below.
1
At the main menu, select in the following order:
"Downloads" → "Sounds" → "Melody Editor" →
"Create new."
12-96
after selecting the target notes.
d
and move the cursor to
a
2
Enter the title of your original ringtones and
press B.
3
Select the tempo and the type of chords.
The "Score Input" screen appears. For information
on selecting the tempos and the type of chords,
refer to "Setting tempo and the type of chords" on
page 12-94.
4
Press G to input "C."
The "C" note sounds and the "C" crotchet appears in
the "Score Input" screen.
5
Press d to move the cursor.
6
or Press "K" to input "G".
7
While selecting "G" crotchet, press P to
change the length of the note.
"G" crotchet changes to "G" quaver.
8
Press d to move the cursor.
9
Press Q to input a crotchet rest and press P
to change the crochet rest to a quaver rest.
A quaver rest appears next to the "G" note in the
"Score Input" screen.