Resetting The Unit; Remote Control Unit - Kenwood KRF-V6400D Instruction Manual

Tuner
Symptom
Radio stations cannot be received.
Interference

Remote control unit

Symptom
Remote control operation is not possible.

Resetting the unit

Resetting the unit
If the unit is completely inoperable, the display is not normal or a problem cannot be solved even after checking the list in
<Troubleshooting>, it is required to reset the the unit.
While holding down [ ] key on the unit, unplug the power cord and plug it back in.
• Please note that resetting the unit will clear the contents of the memory and return the unit to the state it was in when it left the factory.
Cause
No antenna is connected.
The broadcast band is not set properly.
The frequency of the desired station is not tuned.
Noise due to ignition of an automobile.
Noise due to interference from an electric appliance.
Noise due to a nearby TV set.
Cause
The remote control is not set to the source operation
mode you wish to control.
The remote control has not been changed to the operation
mode for the Kenwood DVD player you wish to control.
Batteries are exhausted.
The remote control unit is too far away from the main
system, controlling angle is too large, or there is an
obstacle between this unit and the remote.
There is an obstacle between this unit and the remote
control unit.
Remedy
Connect an antenna.
Set the broadcast band properly.
Tune in the frequency of the desired station. ‹
Install the outdoor antenna away from the road.
Turn off the power to the appliance.
Install the unit farther away from the TV.
Remedy
Press the appropriate Input Source key to select the source
you wish to control.
Press the [DVD] key to activate the operation mode for the
component you want to control before operation. e
Replace with new batteries.
Operate the remote control unit within the controllable
range.
Remove the obstacle.
)
‹
9
9
45
English