Optional Accessories; Voice Synthesizer Installation; Programmable Tone; Decoder Unit Installation - Kenwood TS-790A Instruction Manual

7. OPTIONAL ACCESSORIES
Be sure to unplug the DC power cable before starting
work.
7-1. VS-2 VOICE SYNTHESIZER INSTAL-
LATION
1. Remove the bottom cover of the transceiver. Refer
to Section 6-6-1.
2. Plug in the 8 pin connector that is located near the
front pane! as shown.
3. Fasten the VS-2 with two binding screws
(M2.6 x 4) provided with the unit.
Caution:
Keep the pan-head screw, binding screw, and pad
provided with the VS-2 for later use. They are not
needed now.
4. Replace the bottom cover.
Note:
Avoid catching your fingers and wiring harness
when closing.
7-2. TSU-5 PROGRAMMABLE TONE
DECODER UNIT INSTALLATION
{TS-790A only)
1. Remove the bottom cover of the transceiver. Refer
to Section 6-6-1.
2.1) MAIN installation
* Remove the protective sheet from the pad and glue
it to the TSU-5.
Caution: -~
Attach as shown in the accompanying illustration.
MAIN
Cushion
© Remove the two-pin jumper plug from the IF unit's
connector (CN40).
© Plug the two-pin connector (with leads) from the
TSU-5 onto CN40, and the seven-pin connector
(with leads) from the IF unit onto the TSU-5.
Caution: aes
Keep the two screws provided with the TSU-5 for
later use. They are not needed now.