Harman Kardon AVR5 Owner's Manual page 17

System Setup
Once the speakers have been placed in
the room and connected, the final step in
the setup process is to enter the settings
that configure the AVR5 for the type of
speakers used in your system, the calibra-
tion of the output levels and the delay
times used by the surround sound
processor. Before proceeding further, this
is a good time to review the installation
section of the manual to make certain
that all connections are properly made.
You are now ready to power up the AVR5
to begin these final adjustments.
1. Plug the
Power Cable ›
unswitched AC outlet.
2. Press the
Main Power Switch 1
in so that it latches in with the "OFF"
wording on the top of the switch
inside the front panel. Note that the
will briefly
Power Indicator 3
turn red, then amber, indicating that
the unit is in the Standby mode.
3. Install the two supplied AAA batteries
in the remote as shown. Be certain to
observe the (+) and (–) polarity
indicators shown in the bottom of the
battery compartment.
System Configuration
4. Turn the AVR5 on either by pressing
the
System Power Control 2
the front panel, or via the remote by
pressing the
. The
ç Power Indicator 3
briefly turn red and then green to con-
firm that the unit is on, and the
Information Display ¯
light up.
Center Speaker Configuration
An initial adjustment tells the AVR5
which type of center speakers are in use.
This is important as it adjusts the settings
that determine if they receive low-
frequency (bass) information. For these
to an settings use the
speakers for a particular position are tra-
ditional full-range loudspeakers that are
capable of reproducing sounds below
100Hz. Use the
er, frequency-limited satellite or center
speakers that do not reproduce sounds
below 100Hz. Note that when "small"
speakers are used, a subwoofer is
required to reproduce low-frequency
sounds. Remember that the "large" and
"small" descriptions do not refer to the
actual physical size of the speakers, but
their ability to reproduce low-frequency
sounds. If you are in doubt as to which
category describes your speakers, consult
the specifications in the speakers' owner's
manual, or ask your dealer.
With the AVR5 turned on, follow these
steps to configure the speakers:
18
on
button
Main Power On
will
will also
setting if the
LARGE
setting for small-
SMALL
1. Put the AVR5 in the Dolby Pro Logic
mode by pressing the
Dolby Pro
on the front
Logic Selector *
panel or by pressing the
on the remote,
Mode Selector
until appears in the
PRO LOGIC
Information Display ¯
indicator lights.
PRO LOGIC
2. Press the button
Center
front panel or the
Center
on the remote.
3. Press the button
Center
front panel or the
Center
on the remote until the desired center
channel speaker type appears in the
Information Display ¯
definitions for "Large" and "Small"
that appear above. If no center channel
speaker is installed, press the button
until the display reads
NONE
in the Information Display.
NOTE: The AVR5's subwoofer output is
always active, regardless of the center
channel configuration setting.
Output Level Adjustment
Output level adjustment is a key part of
the configuration process for any sur-
round sound product. It is particularly
important for a digital-ready receiver
such as the AVR5, as correct outputs will
ensure that you hear sound tracks in their
proper place with the proper intensity.
Surround
and the
on the
ˆ
button
¥
on the
ˆ
button
¥
, using the
as shown