Miele KM 451 Installation Instructions Manual
Ceramic cooktop
Hide thumbs
Also See for KM 451:
- Operating instructions manual (36 pages) ,
- Operating instructions manual (36 pages)
Related Manuals for Miele KM 451
Summary of Contents for Miele KM 451
-
Page 1: Installation Instructions
Installation instructions Ceramic Cooktop KM 451 To prevent accidents and machine damage, read the Operating Manual installation or use. M.-Nr. 05 361 940... - Page 3 KM 451........
- Page 4 The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire. recommended The cabinetry and venting hood should be installed first, to prevent damage to the cooktop. The countertop must be bonded with heat resistant (212 °F/100 °C) 2 ”...
- Page 5 However, under certain circumstances it may be possible for installation in these applications. Please contact the nearest Miele Dealer or the Miele Technical Service Department with specific requirements. Because of the heat radiated downwards from this type of appliance we do not recommend installing it over a drawer.
- Page 6 ( 8 m ( 5 1 4 m ( 5 8 ( 9 3 0 m m ) ma x. R4 ( 8 3 i n . i n . a Spring clips b There must be at least 3 "...
- Page 7 ( 7 5 m 3 ” For granite countertops, the spring clips, a, must be placed in position and secured with strong, double-sided ^ Fix the supplied spring clips, a, at adhesive tape. In addition coat the edges of the spring clips with silicone the marked positions as shown sealant.
- Page 8 ^ Feed the power cord down through the cut-out and connect the appliance to the power supply. The cooktop must not be ^ Position the cooktop on the spring permanently sealed into the clips, a. countertop when installed. The sealing strip under the edge of the ^ Then with a hand on each side of the top part of the cooktop provides a cooktop press down on the edges...
- Page 9 All electrical work should be performed by a qualified electrician The appliance is provided with 3 leads; in accordance with local and L1 (black), L2 (red) and GND (green). national codes. They must be connected to a Disconnect the appliance from the dedicated line through the use of an main power supply before servicing.
- Page 12 Alterations rights reserved / 0705 M.-Nr. 05 361 940 / 02 en - US...