Miele KM427 Installation Instructions Manual
Ceramic
Hide thumbs
Also See for KM427:
- Specification (1 page) ,
- Technical manual (50 pages) ,
- Operating instructions manual (24 pages)
Advertisement
Quick Links
Download this manual
See also:
Technical Manual
Installation Instructions
Ceramic Cooktops
KM 421
KM 424
KM 427
UV
To prevent accidents
and machine damage,
read these instructions
installation or use.
M.-Nr.
05 647 580
Advertisement
Related Manuals for Miele KM427
Summary of Contents for Miele KM427
-
Page 1: Installation Instructions
Installation Instructions Ceramic Cooktops KM 421 KM 424 KM 427 To prevent accidents and machine damage, read these instructions installation or use. M.-Nr. 05 647 580... - Page 2 ........3 Installation .
- Page 3 2 ” The minimum distances given in these instructions must be observed to ensure safe operation and to re- duce the risk of fire. recommended To prevent damage, install cabinetry and the venting hood before install- ing the cooktop. The countertop must be bonded 2 ”...
- Page 4 Please contact the nearest 2 ” Miele Dealer or the Miele Technical Ser- 50mm vice Department with specific require- ments. Because of the heat radiated from this type of appliance we do not recommend installing it over a drawer.
- Page 5 ( 8 5 m ( 8 m ( 6 1 4 2 m m m m ) ( 5 3 ( 8 5 i n . * max.R3/16 max.R4mm ( 6 0 a Spring clips ^ Make the countertop cut-out following If, during installation, the seal around the dimensions given in the illustra- the frame does not sit flush with the...
- Page 6 ( 8 5 m ( 8 m m m ) ( 7 6 3 m ( 5 3 2 ( 8 5 * max.R3/16 max.R4mm ( 7 4 a Spring clips ^ Make the countertop cut-out following If, during installation, the seal around the dimensions given in the illustra- the frame does not sit flush with the tion.
- Page 7 ( 8 5 m ( 8 m ( 8 5 ( 5 3 2 m ( 9 0 3 m m ) * max.R3/16 max.R4mm i n . ( 8 8 a Spring clips ^ Make the countertop cut-out following If, during installation, the seal around the dimensions given in the illustra- the frame does not sit flush with the...
- Page 8 ( 7 5 m 3 ” For granite countertops, the spring clips, b, must be placed in position and secured with double-sided tape. In addition, coat the edges of the ^ Fix the supplied spring clips, a, at spring clips with silicone sealant. the marked positions as shown The screws are not needed for granite above, by laying them on the upper...
- Page 9 ^ Feed the power cord down through the cut-out and connect the appli- ance to the power supply. ^ Position the cooktop on the spring clips, a. The cooktop must not be perma- nently sealed into the countertop ^ Then with a hand on each side of the when installed.
- Page 10 All electrical work should be per- formed by a qualified electrician in The appliance is provided with 3 leads; accordance with local and national L1 (black), L2 (red) and GND (green). codes. They must be connected to a dedi- Disconnect the appliance from the cated line through the use of an ap- main power supply before servicing.
- Page 12 Alteration rights reserved / 1902 M.-Nr. 05 647 580 / V This paper consists of cellulose which has been bleached without the use of chlorine.