Using The Amplifiers As Independent Power Amplifiers - Behringer Powerplay Pro HA4400 User Manual

POWERPLAY PRO HA4400
Fig. 5.1: Example of a studio playback application

5.2.1 Using the amplifiers as independent power amplifiers

In addition to the joint control of all channels via the MAIN input, each of the four power amplifiers can also be
used independently. The AUX IN inputs in combination with the BALANCE controls serve this purpose.
If the BALANCE control is set to its clockwise stop position (position "AUX"), the MAIN signal is muted; only
the input signals applied to the AUX IN input are routed to the power amplifier. By configuring the amplifiers as
completely independent power amplifiers, you can insert up to four independent stereo programme sources;
thus, four different and individual mixes for up to four musicians can be created. As with a stage monitor
system, you can give each musician a specific configuration of instruments and create a personal mix for him
or her that is musically inspiring. Or you can set up different signal paths for the interpreters in a conference
system.
Configure sub-groups or create pre-mixes using the effects and/or monitor facilities of your mixing console.
Fully turn up the BALANCE control and connect the AUX inputs of the BEHRINGER POWERPLAY PRO to the
corresponding monitor, sub-group or single outputs of the mixer.
Fig. 5.2: Example of monitor inserts in a stage application
12 5. APPLICATION