Advertisement
10
FOUR PLAY
Power Connection
The Four Play module comes with the required
power cable for connecting to a standard Eurorack
power supply system. Follow these steps to
connect power tothe module. It is easier to make
these connections before the module has been
mounted into a rack case.
1. Turn the power supply or rack case power off
and disconnect the power cable.
2. Insert the 16-pin connector on the power cable
into the socket on the power supply or rack
case. The connector has a tab that will align
with the gap in the socket, so it cannot be
inserted incorrectly. If the power supply does
not have a keyed socket, be sure to orient pin 1
(-12 V) with the red stripe on the cable.
3. Insert the 10-pin connector into the socket on
the back of the module. The connector has a
tab that will align with the socket for correct
orientation.
4. After both ends of the power cable have been
securely attached, you may mount the module
in a case and turn on the power supply.
Installation
The necessary screws are included with the
module for mounting in a Eurorack case. Connect
the power cable before mounting.
Depending on the rack case, there may be a series
of fixed holes spaced 2 HP apart along the length
of the case, or a track that allows individual
threaded plates to slide along the length of the
case. The free-moving threaded plates allow
precise positioning of the module, but each plate
should be positioned in the approximate relation
to the mounting holes in your module before
attaching the screws.
Hold the module against the Eurorack rails so
that each of the mounting holes are aligned with
a threaded rail or threaded plate. Attach the
screws part way to start, which will allow small
adjustments to the positioning while you get
them all aligned. After the final position has been
established, tighten the screws down.
11
Quick Start Guide
Advertisement
