The Ultrabass As A Slave With An External Pre-Amp; Installation; Audio Connections - Behringer Ultrabass BXL450 User Manual

ULTRABASS
If you want the bass signal to go through a PA system during live
gigs, you would normally need a DI box. (DI boxes process the
signals for long cables and provide a higher output level at the
mixing console). The ULTRABASS amps have a DI box already
built in! Connect the balanced DI OUT directly to the mixing console
input or to the multi-core cable leading to the console. Use a
microphone cable (2-core shielded cable with XLR connectors).
Alternatively, you can use the LINE OUT (¼" TS jack) for short
cables and mixing consoles with line-level inputs (e.g. for
recording in your home studio without having to use a
microphone). Of course, you can also use this output as an
additional send path or to connect a tuner.
4.3 The ULTRABASS as a slave with an
external pre-amp
If you wish to use another bass preamp or modeling amp
(e. g. BASS V-AMP or BASS V-AMP PRO), you can connect this
amp to the FX INSERT RETURN jack. In this configuration, the
ULTRABASS is used as a power amp only, and the two input
channels are disabled.
8
BXL450/BXL900/BXL1800/BXL3000
Except for the headphones output, all
BEHRINGER ULTRABASS are ¼" TS connectors. The DI output
is on a balanced XLR connector. The CD inputs are on RCA
connectors.
+

5. INSTALLATION

5. INSTALLATION

5.1 Audio connections

Fig. 5.1: XLR connections
Fig. 5.2: ¼" TS connector
Fig. 5.3: ¼" stereo TRS connector for PHONES
" jacks on the