Table of Contents
Advertisement
Chapter 2: Macintosh Installation
This chapter describes how you can use your scanner with your Macintosh computer.
Connect the Scanner to your Computer
1.
Ensure that the scanner's SCSI ID is properly set. Refer to the "Change the
SCSI Number" section in Chapter 1 for instructions on setting the scanner's
SCSI ID.
2.
Connect the SCSI cable to your Macintosh's SCSI port and connect the other
end of the SCSI cable to the scanner.
Note: If your scanner is not chained to other SCSI devices and is the last
3.
Connect the power cord to the scanner. And connect the other end of the
power cord to a grounded power socket.
4.
Turn on the scanner power.
5.
Turn on the computer power .
Installing the Software
Install the software in the following order:
1.
Image Application Software, e.g. binuscan PhotoPerfect, Adobe Photoshop.
2.
Then, MagicScan.
MagicScan is the interface used by application software to control UMAX scanners. Its
advanced controls allow precise adjustments in images even during the initial scan.
For detailed information on installing the software, refer to the Installation section of
the Image Application Software User's Guide and MagicScan Electronic Books.
device, please connect the terminator to the remaining SCSI port of
your scanner.
Terminator
7
Advertisement
Table of Contents
