Your Manual is divided into two parts: the set-up instructions and the device codes. PLEASE DO NOT DISCARD THIS MANUAL AS YOU MAY NEED IT AGAIN IN THE FUTURE! Your ONE FOR ALL 2 can operate two devices: a Television and a Video Recorder. WWW.ONEFORALL.COM...
The Magic key is used to set-up your ONE FOR ALL 2 Remote Control and to access special functions. LED: During the use of your ONE FOR ALL 2, the LED will light up red. Power Key: The Power key controls the same function as it did on your original remote.
Page 5
The Keypad OK key If your original remote control required that you press an “OK” or “ENTER” key during Menu operation, this key can be used for this function. Menu Key: Controls the same function as it did on your original remote control. Exit Key: The Exit key will exit the Menu.
Setting up the ONE FOR ALL 2 (How to set-up the ONE FOR ALL 2 to control your devices) Direct code set-up Example: To set up the ONE FOR ALL 2 for your television: Make sure your device (television) you wish to operate is switched on (not in standby).
Setting up the ONE FOR ALL 2 Search method --> If your device does not respond to the ONE FOR ALL 2 after you have tried all the codes listed for your brand. --> If your brand is not listed at all.
Code blink out (To find out which code is currently programmed) Once you have Set-Up your ONE FOR ALL 2, you can blink back your Set-up Code for future reference. Example: to blink out your television code: Press the TV key once.
It is possible to change the mode of any device key. This is useful if you want to set up two of the same devices on the ONE FOR ALL 2. The code can be set up using “Direct code set up” (p. 6) or “Search method” (p. 7).
For example: if you are watching a program on your video recorder, you can adjust the volume (a TV function) without pressing the TV mode key on your ONE FOR ALL 2. The table below lists some of the possibilities.
B) Try the search method on page 7. The ONE FOR ALL 2 is not You may be using the wrong performing commands code. Try repeating the Direct properly? Set-Up using another code listed...