Windshield Wipers - Oldsmobile ALERO 2001 Owner's Manual

Flash-to-Pass
This feature lets you use your high
signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever toward
-
you until the high beam headlamps come on, then
release the lever to turn them off.

Windshield Wipers

You control the windshield wipers by moving the lever
with the wiper symbol on it up or down.
2-40
-
beam headlamps to
For a single wiper cycle, push the lever down to
MIST, then release it. For more cycles, hold the lever
down longer.
For steady wiping at low speed, move the lever up to the
-
LO position. For high speed wiping, move the lever up
further, to HI. To stop the wipers, move the lever to OFF.
You can set the wiper speed for a long or short delay between
wipes. This can be very useful in light rain or snow.
Move the lever to INT, then turn the inner band, labeled
INT ADJ, and choose the delay you want. Turn the inner
band up for shorter delay times between wiper cycles.
Turn the band down for a longer delay time between
wiper cycles.
Remember that damaged wiper blades may prevent you
from seeing well enough to drive safely. To avoid
damage, be sure to clear ice and snow from the wiper
blades before using them. If they're frozen to the
windshield, carefully loosen or thaw them. If your
blades do become damaged, get new blades or
blade inserts.
Heavy snow or ice can overload your wiper motor. A
circuit breaker will stop the motor until it cools. Clear
away snow or ice to prevent an overload.