Audio Setting - Sharp CD-SW250DVD Operation Manual

Parental setting (continued)
CD-SW250DVD
ENGLISH
Changing the parental level
H
1
Whilst a disc is stopped, press the SET UP button whilst
pressing down the SHIFT button to display the setup
screen.
2 Use the cursor 3 or 4 button to select the "
TAL".
3
Press the ENTER button to display the password verifica-
tion screen.
4
Use the 0 - 9 buttons to enter the 4-digit password that was
set previously.
I If you forget your password, you can erase your current password by
pressing DVD STOP H button four times.
I Then repeat step 4 on page 26 again to enter the default password.
5
Press the ENTER button to select level.
Use the cursor 1, 2 button to change the parental level.
E-27
SW250DVD_23-27_EN+ 27

Audio setting

PAREN-
Setting the Dolby Digital Out
H
1
Whilst a disc is stopped, press the SET UP button whilst
pressing down the SHIFT button to display the setup
screen.
2
Use the cursor 3 or 4 button to select the "DIT/DA Output".
3
Press the ENTER button and
then use the cursor 3 or 4
button to select "DOLBY
DIGITAL".
4
Use the cursor 2 or 3 button to select "STREAM" or "PCM".
STREAM:
Use this setting for a digital connection of a receiver
(amplifier) equipped with a Dolby Digital decoder.
PCM:
Use this setting for a digital connection to the PCM
digital input socket of a DAT or MD, or for a digital
connection to a receiver (amplifier) that does not
have a Dolby Digital decoder.
To exit the setup screen and return to the startup screen, press the SET
UP button whilst pressing down the SHIFT button or the RETURN button.
27/4/05, 4:31 PM
DIT/DA output
DOLBY DIGITAL STREAM
DIT On
98kHz LPCM 98kHz
SELECT SAVE & QUIT SET UP