Setting The Clock - Sharp CD-SW200H Operation Manual

Setting the clock

In this example, the clock is set for the 24-hour (0:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the
select "CLOCK", and press the MEMORY/SET (MEMORY)
button.
4
Press the or button to select 24-hour or 12-
hour display and then press the MEMORY/SET (MEMORY)
button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"AM 0:00" The 12-hour display will appear.
(AM 0:00 - PM 11:59)
5
Press the
then press the MEMORY/SET (MEMORY) button.
Press the
1 hour. Hold it down to advance continuously.
6
Press the
then press the MEMORY/SET (MEMORY) button.
Press the
1 minute. Hold it down to change the time in 5-minute intervals.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
or button to
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the
time.
The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time dis-
play when the AC power supply is restored after a power failure or
unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" does not
appear in step 3, step 4 (for selecting the 24-hour or 12-hour dis-
play) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 42 for details.]
2 Perform "Setting the clock" from step 1.
Note:
The clock can also be set with the remote control.
26/4/05
or button to adjust the hour and
or button once to advance the time by
or button to adjust the minutes and
or button once to advance the time by
or button to display the
CD-SW200H(H)_EN.fm
TINSZA165AWZZ
CD-SW200H
ENGLISH
1
2
3
4
5
6
7
8
E-12