Rear Panel Connections - Harman Kardon HKTS 2 Owner's Manual

Rear Panel Connections

Subwoofer-Level Control
High-Cut (Low-Pass) Filter Switch
Trigger Input
Phase Switch
Subwoofer-Level Control: Volume
may be adjusted using the Subwoofer-Level
Control. Turn the control clockwise to increase
the subwoofer's volume, or counterclockwise to
decrease it.
High-Cut (Low-Pass) Filter Switch: Plac-
ing this switch in the position activates cir-
ON
cuitry that cuts out all audio input signals above
120Hz. This allows the subwoofer to focus its
power on reproducing the low-frequency portion
of the signal, avoiding inefficiency and
distortion. Engage this filter when using the
Speaker-Level Inputs , or when using the
Line-Level Full-Range Inputs
receiver or processor processes its line-level
output using a low-pass filter. The filter has no
effect when the Sub Input is used.
4 REAR PANEL CONNECTIONS
Line-Level Subwoofer (SUB) Input
Line-Level Full-Range Inputs
Speaker-Level Outputs
Speaker-Level Inputs
Trigger Input: Some receivers or sound
processors have a Trigger Output that sends a
signal to the subwoofer to switch on or off. If
your receiver has such a Trigger Output, connect
it here. When placed in the
when the Master Power Switch
on, the subwoofer will automatically turn itself
on or place itself in the Standby mode,
depending on the status of your receiver or
processor. When this switch is placed in the
position, the subwoofer will remain on, whether
or not it is receiving an audio signal.
, unless your
SUB-TS2
CAUTION CAUTION
RISK OF ELECTRIC SHOCK RISK OF ELECTRIC SHOCK RISK OF ELECTRIC SHOCK
DO NOT OPEN DO NOT OPEN DO NOT OPEN
Master Power Switch
AC Power Cord
An LED located on top of the subwoofer
indicates whether the subwoofer is in the On or
standby state when used with the Trigger
On/Off Switch
position, and LED is lit blue to indicate that the subwoofer is
AUTO
is turned receiving an audio signal and is turned on, and
the LED is lit amber to indicate that no signal is
being received and the subwoofer is in Standby
mode.
ON
When the Trigger On/Off Switch
position, the LED will be lit blue, whether or
ON
not an audio signal is present.
When the Master Power Switch
off, the LED goes dark, no matter which position
the Trigger On/Off Switch
For use with
HKTS 2BQ,HKTS 2WQ
HKTS 2 System
in the position. The
AUTO
is in the
is turned
is in.