Rear Panel Connections - Harman Kardon HKTS 11 Owner's Manual

Rear Panel Connections

¡
FILTER
ON
™
MIN
OFF
£
ON
AUTO
¢ REVERSE
NORMAL
∞
SUB
LINE
LEVEL
IN
§
L
H
I
G
H
¶
L
E
V
E
L
R
•
OUT
ª
IMPORTANT: CONNECT STRIPED WIRE
TO RED ( ) SPEAKER TERMINAL.
‚
Subwoofer-Level Control
High-Cut (Low-Pass) Filter Switch
Music-Sense On/Off Switch
Phase Switch
Subwoofer-Level Control: Volume
may be adjusted using the Subwoofer-Level
Control. Turn the control clockwise to increase
the SUB-TS11's volume, or counterclockwise to
decrease it.
High-Cut (Low-Pass) Filter Switch: Plac-
ing this switch in the position activates cir-
ON
cuitry that cuts out all audio input signals above
120Hz. This allows the SUB-TS11 to focus its
power on reproducing the low-frequency portion
of the signal, avoiding inefficiency and distor-
tion. Engage this filter when using the Speaker-
Level Inputs , or when using the Line-
Level Full-Range Inputs , unless your
receiver or processor processes its line-level out-
put using a low-pass filter. The filter has no
effect when the Sub Input is used.
4 REAR PANEL CONNECTIONS
SUBWOOFER
LEVEL
MAX
PHASE
L
R
IN
Line-Level Subwoofer (SUB) Input
Line-Level Full-Range Inputs
Speaker-Level Outputs
Speaker-Level Inputs
Music-Sense On/Off Switch: When
placed in the
AUTO
Master Power Switch
SUB-TS11 will automatically turn itself on or
place itself in the Standby mode, depending on
whether it is receiving an audio signal. When
this switch is placed in the
SUB-TS11 will remain on, whether or not it is
receiving an audio signal.
An LED located on top of the SUB-TS11 indi-
cates whether the SUB-TS11 is in the On or
standby state when used with the Music-Sense
On/Off Switch
LED is lit blue to indicate that the SUB-TS11 is
receiving an audio signal and is turned on, and
the LED is lit amber to indicate that no signal is
being received and the SUB-TS11 is in Standby
mode.
SUB-TS11
RISK OF ELECTR IC SHOCK RISK OF ELECTR IC SHOCK RISK OF ELECTR IC SHOCK
"WARNING: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE T 2.5A L/250 VOLT FUSE"
"AVERTISSEMENT: UTILISEZ UN FUSIBLE DE RECHANGE DE MEME
TYPE T 2.5A L/250V"
When the Music-Sense On/Off Switch
position, and when the in the
is turned on, the whether or not an audio signal is present.
When the Master Power Switch
off, the LED goes dark, no matter which position
the Music-Sense On/Off Switch
position, the
ON
whether the SUB-TS11 subwoofer's piston-like
action moves in and out in phase with the main
speakers. If the speakers were to play out of
phase, the sound waves produced by the sub-
woofer would be cancelled out, reducing bass
in the position. The
AUTO
response. This phenomenon depends in part on
the relative placement of the speakers in the
room. In most cases, the Phase Switch
should be left in the
ever, it does no harm to experiment with the
Phase Switch
position that maximizes bass response.
For use with
HKTS 11 System
CAUTION CAUTION
DO NOT OPE N DO NOT OPE N DO NOT OPE N
POWER
AC 230V~50Hz
Master Power Switch
AC Power Cord
position, the LED will be lit blue,
ON
Phase Switch: This switch determines
position. How-
NORMAL
, and you may leave it in the
is
is turned
is in.