Harman Kardon HKTS 2 Owner's Manual page 10

Speaker Connections
Use this installation method for Dolby Pro Logic
or Dolby Virtual Speaker applications (not Dolby
Digital, DTS ® or other digital processing), where
the receiver/processor is equipped with a
subwoofer output, or a volume-controlled
preamp (line-) level output:
Use RCA-type patch cords to connect the line-
level subwoofer output on your receiver or to
amplifier either the left or right line-level input
on the subwoofer.
Front
Left
– +
10 SPEAKER CONNECTIONS
Use both the left and right inputs on the sub-
woofer if your receiver or processor has both left
and right line-level outputs. In that case, you will
need to supply a second interconnect cable.
If your receiver is equipped with line-level out-
puts but does not have a separate subwoofer
output, use a Y-adapter (not supplied) to bridge
the receiver's preamp output to the main amp
input for that channel, and connect the long end
of the adapter to the corresponding line-level
input on the subwoofer.
IMPORTANT: Do not use the Sub Input
the subwoofer with Dolby Pro Logic processors.
SUB-TS
Subwoofer
Line-Level
R
Front
Left
SUB/LFE
Out
Receiver
If your receiver/processor has a built-in low-
pass-crossover filter for the subwoofer output,
you may use the Sub Input
subwoofer's internal crossover.
Connect each speaker to the corresponding
speaker terminals on your receiver or amplifier.
Make sure that you have configured your
surround sound processor for "Subwoofer On."
The left and right speakers should all be set to
"Small."
When all connections have been made, plug the
on
AC power cord on the subwoofer into an AC
outlet.
L
Front
Right
to bypass the
Front
Right
– +