Recording From A Cd (Cds) - Sharp CD-E110H Operation Manual

Recording to a cassette tape
CD-E110H
ENGLISH
Before recording:
" When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
" SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
" The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
" For recording, use only normal tapes. Do not use metal or
CrO tapes.
" Recording can be operated in the TAPE 1 compartment only.
The TAPE 2 compartment is for playback only.
E-19
Erase-prevention tab of cassette tapes:
" When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
" To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on the
tape without the tab.

! Recording from a CD (CDs)

You can record 3 CDs continuously.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 1 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the CD button and load the desired disc.
4
Press one of the 1 - 3 buttons on the remote control to
select the disc to be recorded first.
5
Press the button of TAPE 1,
which also engages the but-
ton.
CD playback and tape recording will start.
To stop recording:
Press the button of TAPE 1.
To perform programmed recording:
1 Press the CD button.
2 Programme discs and tracks. (See page 15.)
3 Press the button of TAPE 1, which also engages the
03/1/21 CD-E110H(H)E2.fm
Side A
Tab for Tab for
side B side A
button.