Alcatel-Lucent 5620 User Manual page 135

5 Click on the Select button to choose a VLAN path to associate with the Cpipe
service. The Select VLAN Path - Cpipe Service form opens.
6 Choose a VLAN path and click on the OK button. The Select VLAN Path - Cpipe
Service form closes and the Cpipe Service (Create) form reappears with the VLAN
path information displayed on the General tab.
7 Configure the parameters:
•
•
The VLAN ID parameter is enabled when the Auto-Assign ID parameter is disabled.
8 Configure the Service Class parameter.
9 If you specified the CEM to Eth option in step 8, configure the parameters:
•
•
•
The VLAN ID parameters are enabled when the associated Auto-Assign ID
parameter is disabled.
10 If you set the Service Class parameter to the SDH to SDH option in step 8, configure
the parameters:
•
•
11 In the navigation tree, right-click on a 9500 MPR Cpipe Service and choose Create
Cpipe Site. The Select Network Elements - Cpipe Service form opens with a list of
available 9500 MPR sites.
For information about adding a GNE site to a VLL service, see Procedure 11-4.
12 Choose a site and click on the OK button. The Select Network Elements - Cpipe
Service form closes and the Cpipe Site (Create) form opens with the General tab
displayed.
Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
Note 1 — If no VLAN path exists, see Procedure
about how to create a VLAN path.
Note 2 — You cannot create VLL Cpipe services on a 9500 MPR using the
5620 SAM if the associated VLAN path spans across adjacent physical
links. The VLL Cpipe service must have at least one radio link. If
required, contact your Alcatel-Lucent technical support representative
for alternative VLL Cpipe service configuration options.
Auto-Assign ID
VLAN ID
EC ID Tx
Auto-Assign ID
EC ID Rx
Clock Source
Jitter Buffer Depth
11 — 9500 MPR VLL service management
10-2
Auto-Assign ID
•
Clock Source
•
Mac Address
•
September 2013
for information
11-7