Mitsubishi Electric WD-60C9 Basic Owner's Manual page 23

Troubleshooting
23
Sound
Symptom
1. There is no sound even when the
volume is turned up.
2.
The sound does not match the screen
picture.
3. The sound from my AN receiver does
not match the screen picture (I should
hear the correct audio from my
AN
receiver).
4. Cannot select an audio-only device; it
does not appear in the Activity menu.
Remarks
• Check if the MUTE button is on.
• The TV's "Listen to:" setting may be set to SAP (analog program
from the ANT input).
• Check that the Speakers option is set to TV to hear sound from the
TV speakers. Sound may be being sent to one of the audio outputs
for an AN receiver or headphones.
• If using an AN receiver, check that the Speakers option is set to AV
Receiver to hear sound from the AN receiver speakers.
• Press and hold the POWER button on the control panel for 10
seconds to perform System Reset.
The TV's "Listen to:" setting may be set to SAP (analog program from
the ANT input).
Check that DIGITAL AUDIO OUTPUT and/or AVR AUDIO OUTPUT
on TV's back panel is connected to the
AN
receiver.
Without this connection, devices connected only to the TV (and not
the AN receiver) can be heard only from the TV speakers. Note that
this includes the ANT input, a device (such as a camcorder) con-
nected to the front panel, and any other device sending audio to the
TV only.
Plug an unused video plug into the INPUT 3
YIVIDEO
jack to activate
Auto Input Sensing and make the audio device selectable in the
Activity menu.