Grid And Plate Positions - Smeg BQ6030T Instructions For The Installer

Instructions for the User

9.3 Grid and plate positions

Before starting to cook, always check that the grids, refractory plates and stainless steel / cast iron plate
are correctly positioned. The diagram illustrates the correct positions for the plates A and grids B.
4
3
1
C
5
A
2
The self-cleaning refractory plates (A) must be fitted on the rests 1 and 2 shown below.
The grids (B) or the stainless steel / cast iron plate (C) have two rests of different heights at the rear (3
and 4) on which they can be placed. This means they can be moved closer to or further from the
refractory plates (A) depending on the heat level required, and also to use the fat for cooking by tilting
them if so desired.
Only in the configuration shown in the figure, with all the plates and grids correctly installed, can the
barbecues be used for cooking: any other configuration is a source of hazard to the user and can
compromise the operation of the appliance as well as damaging its exterior.
The refractory plates (A) must only be fitted underneath the grids (B) and not underneath the
stainless steel/cast iron plate (C).
Take care not to obstruct the combustion gas outlet flue in the back of the lid.
GAS OUTLET FLUE
41