Table of Contents
Advertisement
Instructions for the Installer
7.6 Fixing the gas cylinder to the trolley (optional)
To secure the gas cylinder to the trolley, use the chain provided, passing it through the points shown in
the diagram.
Fit one link of the chain over the pin A, then pass it over points B and C on the top of the cylinder,
through the hole D and underneath the frame. Then bring the chain out of the frame in point E, fix it to
the pin A again and tighten the ring-nut.
If the pin which secures the chain has to be replaced, refer to the illustrations below which show how to
fit and fix the pin.
1)
2)
7.7 Hose clip
There is a hose clip on the trolley. It must be used to prevent the hose from touching other surfaces in the
section between the appliance's gas connection and the cylinder connection.
The bottom of the carriage is able to take gas cylinders up to 50 cm tall (with pressure regulator fitted).
The pressure regulator outlet should be horizontal.
37
Advertisement
Table of Contents
