Table of Contents
Advertisement
Special programmes
retirar pelusas/fios (Fluff Clean)
This programme is executed to clean the drying circuit of any fluff
deposits. The time at which the programme needs to be run is determined
automatically by th
automatically by the washer-dryer and indicated by the
pelusas/fios (Fluff Clean) symbol remains lit until the programme has
been successfully completed.
To run the retirar pelusas/fios (Fluff Clean) programme, proceed as
follows:
Make sure that the drum is completely empty and close the door.
Set the programme selector to retirar pelusas/fios (Fluff Clean).
Press the inicio pausa (Start/Pause) button.
At the end of the programme, the retirar pelusas/fios (Fluff Clean)
symbol goes out.
You can also run the retirar pelusas/fios (Fluff Clean) programme at any
i
time without prompting from the appliance.
'+centrigug.B (Rinse + Spin)
An additional rinse cycle with a final spin. If the laundry is to be removed
dripping wet, set the spin speed to $ (Rinse stop) before starting the
programme → page 13.
t
+centrifug. B (Empty + Spin)
Drain the rinsing water following a programme with $ (Rinse stop)
→ page 13.
Turn the programme selector to
Set the spin speed to $ (Rinse stop).
Press the inicio pausa (Start/Pause) button.
or
Drain and spin at the desired spin speed:
Turn the programme selector to
Press the B (Spin) button repeatedly until the desired spin speed is
set.
Press the inicio pausa (Start/Pause) button.
symbol on the display panel. The n is determined
?
:
:
t
+centrifug.B
t
+centrifug.B
?
retirar
?
(Empty + Spin).
(Empty + Spin).
12
Advertisement
Table of Contents
