Before Using Your Washing Machine For The First Time - Siemens XLM 700 Instruction Manual And Installation Instructions

Before Using Your Washing
Machine For the First Time
10
Caution
The washing machine must have been installed and
connected properly (refer to Page 37).
Your appliance was tested before leaving the factory.
To remove any water left over from testing procedu
res, the first washing cycle should be carried out
without laundry in the machine.
i Do not load any laundry.
1. Turn on water tap.
2. Pull out the detergent dispenser up to the end
stop.
3. Pour approx. 1 litre / 1 ¾ pt of water into
chamber II of the detergent dispenser.
4. Pour ½ measuring beaker of detergent into
dispenser II. Do not use any special detergents
for delicates or woollens (excessive foam).
5. Close the detergent dispenser.
6. Set the programme selector to 90 C Cottons.
The On indicator light is on.
7. Press the Start button.
The Active indicator light is on.
When the End control light comes on:
8. Turn the programme selector to Off.