Installing A Hard Drive - Transcend StoreJet 3.5 User Manual

Your StoreJet
Drive. It is IMPORTANT! that you match and install the correct Hard Drive to the correct
enclosure.

Installing a Hard Drive

If you purchased a Transcend StoreJet
already installed, please read this section, otherwise you can skip to the "Driver Installation" section. Your
™
Transcend StoreJet
important that you match and install the correct hard drive to the correct enclosure. You can identify the
type of enclosure by its part number. Enclosures with the Transcend part number TS0GSJ35-S support
SATA Drives, while enclosures with the part number TS0GSJ35 support IDE Drives.
1. Open the StoreJet
the diagram.
2. Remove the cover revealing a control board adapter; this converts the IDE, or SATA interface
connector of the hard drive to a USB 2.0 B-Type interface. Slide out the control board.
Installing a Hard Drive
™
3.5 HDD Enclosure is capable of supporting an IDE, or a SATA Hard Disk
™
3.5 HDD Enclosure that does not have a Hard Disk Drive
3.5 HDD Enclosure is capable of supporting an IDE, or a SATA Hard Drive, it is
™
3.5 by removing the two screws from either side of the top cover, as indicated in
Figure 2. Remove the screws from the top cover
Figure 3. Remove the top cover revealing the IDE/SATA adapter
7