Texas Instruments TI-82 STATS Manual Book page 353

Transmitting
Items to an
Additional
TI-82 STATS
After sending or receiving data, you can repeat the same
transmission to additional TI-82 STATS units—from either the
sending unit or the receiving unit—without having to reselect
data to send. The current items remain selected.
Note: You cannot repeat transmission if you selected All+ or All ..
To transmit to an additional TI-82 STATS, follow these steps.
1. Set the TI-82 STATS to receive (page 19
2. Do not select or deselect any new items to send. If you select
or deselect an item, all selections or deselections from the
previous transmission are cleared.
3. Disconnect the link cable from one TI-82 STATS and
connect it to the additional TI-82 STATS.
4. Set the additional TI-82 STATS to receive (page 19
5. Press y [
LINK
menu.
LINK SEND
6. Select the menu item that you used for the last transmission.
The data from your last transmission is still selected.
7. Press ~ to display the
8. Confirm that the receiving unit is set to receive (page 19
9. Press Í to select
] on the sending TI-82 STATS to display the
LINK TRANSMIT
1:Transmit
Communication Link 19–7
5).
.
.
menu.
and begin transmitting.
5).
5).
.