Tool Set Up; Operating Instructions - Chicago Electric 92772 Set Up And Operating Instructions Manual

OPERATING INSTRUCTIONS

Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.

Tool Set Up

FROM ACCIDENTAL
OPERATION:
Squeeze and release the Trigger
to put it in its off position and
unplug the tool from its electrical
outlet before adjusting tool or
installing accessories.
1. SAW BLADE INSTALLATION:
a. Slide the Blade Guard (9) up to expose
the Blade Guide Assembly (38).
b. Slightly loosen the two Hex Screws (16)
on the Blade Guide Assembly (38).
c. Insert the Saw Blade (59, 60) upward
into the Blade Guide Assembly (38),
and retighten the two Hex Screws (16)
to secure the Saw Blade in place.
Make sure the teeth of the Saw Blade
face forward as shown.
d. Then, lower the Blade Guard (9) to its
original position.
Page 10
TO PREVENT
SERIOUS INJURY
For technical questions, please call 1‑800‑444‑3353.
2. LASER GUIDE BATTERY
INSTALLATION:
a. Remove the Battery Compartment Lid
(57) on the front of the Jigsaw to expose
the Battery Compartment.
b. Install two "AAA" size Batteries (not
included) in the Compartment, making
sure to match the polarity of contacts as
indicated in the Compartment.
c. Then, reattach the Battery Compartment
Lid.
3. BEVEL ADJUSTMENT:
The Base Plate (41) can be tilted to cut
any angle between 0 and 45° right and
left.
a. Loosen the Hex Screw (16). Rotate the
Base Plate right or left to the desired
angle of cut.
b. Then, retighten the Hex Screw (16).
SKU 92772